Update: Added a wall mount / stand, which can be attached to the Dragon head (without neck) version from this post (not the one on MakerWorld) ♥ ------------------------------------------------------------------------------------------------------------------I heard some of you like big prints, so here comes a larger version of my Dragon Lamp, which can also be used as a Headset Holder.
Please use this file separately from the short version of the Dragon Lamp, as I changed the bottom of the head to fit the neck. I added two pins and corresponding holders to make assembly and gluing easier for you.
! IMPORTANT: The bottom layer of the head and the top layer of the neck need to be super thin, so that light can actually pass through to the neck. The neck is printed upside down, so the most important slicer setting is "bottom shell layers = 1" for both objects. Print Settings (already included in the .3mf):• Head: Tree Supports, bottom shell layer = 1, support blockers on the pin holders at the bottom• Neck: Print upside down, no Supports, bottom shell layer = 1 • Teeth, lid, pins: No Supports • Infill: 3% Aligned Rectilinear I like to use a cool plate + glue stick but be careful while removing the objects from the print plate. Since the bottom is only 1 layer thick, it can tear if handled roughly.Printed in Bambu PLA Translucent Lavender (13711)I had this vision of the Dragon Lamp from the start and hope you like this one as much as I do! ♥